Twenty20 LED and HID Canbus Decoders

Works Great on my T-Cross H8 LED Fog lights

Advantages: No errors or flashing - really easy to fit ( plug & play )

Disadvantages: None

Used these on 2013 Mini Cooper. I had swapped up the halogen for LED's, Twenty20 but although lights worked ok got flickering when I started the car (flickering lasts just a few seconds) and warning on the dash every few minutes
There is actually a pair of these in the box, which isn't mentioned on the website.
Easy to fit there is only one way they can get plugged in the only thing is what to do with these once they are hanging in the space behind the bulb.
They come with small zip ties and some self adhesive pads, very little in the way of a flat surface to stick these on.
I ended up using the zip ties doubling the wires over. I will have a look in a couple of weeks and check all is ok
Happy to report the flickering and alarms have both stopped and the Twenty20 LED's are really great so much better than the halogen
I want to change the smaller side lights as well but not sure if i will need a pair of these for those as well

Advantages: Stopped Flickering on start up and dash warning lights

Disadvantages: Difficult to know where to put them once they are fitted to the light bulb holders

Done the job no canbus warning light on now

These can bus decoders has stopped the LED bulbs from flashing when my wife starts up her BMW mini clubman.

Advantages: Can keep using the lovely bright LED headlamps instead of the standard halogen candles!

Disadvantages: The can bus decoders are a little bulky but with a little bit of fettling can be neatly installed by cutting a small hole on one side of the plastic back lid of lamp housing to allow cable to exit.

Excellent item did exactly what it was meant for,easy straightforward fitting.

Advantages: Elevates the problem easily and not overly expensive.

Disadvantages: None.

2014 VW Amarok... I’d fitted the twenty20 H7 led bulbs, but noticed the bulb failure light appear on the dashboard. So I spoke to Kim, in ABD customer service, who recommended these decoders, which DO come as a pair (doesn’t say that on the website), and arrived within a couple of days of ordering.
I connected the decoders to each side, and bingo... no more bulb warning light in the dashboard!! Job done! .

Advantages: Very cheap way of removing the bulb failure light from your dashboard.

Disadvantages: No instructions included, which was initially ok, as they are plug and play... however, there was an additional wire and fuse that I had no clue what to do with. I didn’t end up needing it, but I do worry it’s meant to be attached to something.